How to replace Eva Polymer Bonded Washer

Eva Polymer Bonded Washer is a sealing washer made of EVA material and covered with a layer of black polymer material on its surface to increase its durability and sealing performance. Due to EVA’s good chemical resistance and strength, this material's sealing washers are commonly used in various applications that require advanced sealing performance, such as water pipes, chemical and medical equipment. The characteristic of this sealing washer is that it can resist environmental factors such as ultraviolet, corrosion, and wear, which has high durability, elasticity, and anti-slip performance, making it suitable for high-temperature applications such as solar equipment.

Firstly, locate the part where the Eva Polymer Bonded Washer needs to be replaced, use a wrench or other suitable tool to loosen the fixed nut, so that the original sealing washer can be easily removed. Note that to avoid damage to the parts and reduce the risk of injury, make sure to use the correct tools and safety equipment. Remove the original sealing washer from the screw and clear any debris or corrosion on the screw and sealing surface. Make sure the new size and shape of the Eva Polymer Bonded Washer are the same as the original and suitable for the application. Install the new sealing washer on the screw and ensure it is evenly fixed on the screw. Use an appropriate wrench to tighten the fixed nut, following the manufacturer's recommendations for tightening. Ensure the correct torque is applied to avoid overtightening, damage or failure.